New series! this time with bulbs.
#1
Mach 1 Member
Thread Starter
New series! this time with bulbs.
You can check them out here: http://www.flickr.com/photos/76442934@N00/
More to come soon! tell me what you think!
Matt
More to come soon! tell me what you think!
Matt
#4
Stubborn Bear
TMS Staff
TMS Staff
Thats a great series. Give us details on the shot as to how you did the bulb and all, looks like you maybe cut the glass itself off from around it?
#5
Mach 1 Member
Thread Starter
here is some more: http://www.flickr.com/photos/76442934@N00/?saved=1
I will update with how I make these tomorrow, I'm to tired tonight.
I will update with how I make these tomorrow, I'm to tired tonight.
#6
Mach 1 Member
Thread Starter
To remove the glass I use a small glass cutter and go around the bulb near the base, after I go around it a couple of times I use something (usally a screwdriver) to knock the glass off.
The setup (pictured below) is pretty simple.
The flash is setup to the side facing strait up, with a piece of white foam board placed just above the frame to bounce the light back down onto the smoke.
I hope that answers your question.
Matt
The setup (pictured below) is pretty simple.
The flash is setup to the side facing strait up, with a piece of white foam board placed just above the frame to bounce the light back down onto the smoke.
I hope that answers your question.
Matt
Thread
Thread Starter
Forum
Replies
Last Post
roushcollection
Auto Shows and Events
0
7/28/15 02:08 PM