Dyno'd my new 07'
#1
Dyno'd my new 07'
Only mod so far is Corsa axle-backs. Did two back to back runs on a Dynojet. Car is a manual.
69.71 F, 29.99 in-Hg, 68% Humidity, SAE: 0.98
Run 1: 270.09 RWHP, 286.85 RWTQ
Run 2: 268.86 RWHP, 289.10 RWTQ
Not bad for a stocker, I doubt the Corsa's added much if any.
I am putting on my C&L CAI today and loading the Bamachips 91 Torque tune. I'll dyno it again next week to see the effects.
69.71 F, 29.99 in-Hg, 68% Humidity, SAE: 0.98
Run 1: 270.09 RWHP, 286.85 RWTQ
Run 2: 268.86 RWHP, 289.10 RWTQ
Not bad for a stocker, I doubt the Corsa's added much if any.
I am putting on my C&L CAI today and loading the Bamachips 91 Torque tune. I'll dyno it again next week to see the effects.
#4
Dyno'd again today. Added C&L CAI, and Corsa X-pipe. ( the one you where you cut out the H section and bolt in the X. ) Tune used was Bamachips 91 Race.
Car made 285.21 RWHP and 301.73 RWTQ on the best of two runs. It was a lot hotter today ( 85 F ), and the numbers are great so I'm happy with them.
The X-pipe really changed the exhaust for the better. It made it more "smooth" and "less raspy" sounding. Kind of the opposite of what I have seen them do on 5.0's.
I'm very happy with what this car puts down for such minimal mods.
Car made 285.21 RWHP and 301.73 RWTQ on the best of two runs. It was a lot hotter today ( 85 F ), and the numbers are great so I'm happy with them.
The X-pipe really changed the exhaust for the better. It made it more "smooth" and "less raspy" sounding. Kind of the opposite of what I have seen them do on 5.0's.
I'm very happy with what this car puts down for such minimal mods.
#12
GT Member
Join Date: February 28, 2005
Location: west covina
Posts: 119
Likes: 0
Received 0 Likes
on
0 Posts
What `s your rear gear 3.31 or 3.55 .Mind has 3.55 it`s a o5 dyno last week rwhp 293.18 rwptq 306.68 almost same mod`s .07`s come stock with 3.31`s 3.55 is a option
Thread
Thread Starter
Forum
Replies
Last Post