Hello...anyone have detailed instructions for Delete plates...or is it pretty straight forward. Just trying to save some time. Thanks in advance

 

Its really straight forward..... Just remember you'll need a tune to adjust for them. If you search around this forum, you'll find alot of info on them.

thanks,

tom

 

I haven't done it yet, but from what I read around the net it is quite simple. Clean off the area before you start to disassemble so that no dirt or sand gets in the engine, and line up the runners as best you can before you tighten them down. Also don't disconnect the fuel rails, just take ot the screws that hold them down and shift them over to get to the bolts inside of the manifold. I'd have to see that one for myself...
As soon as I get the new tune from good ol' Doug I'll put mine in a do a small write up.