when im ready to pull out the injectors and fuel rails, what should i do to relieve fuel pressure so i dont make a big mess? Is there even much pressure at the fuel rail? the vehicle hasnt been started in a few days? whats the easiest and fasted way to relieve the pressure if need be?

 

You shouldn't have to worry about it. After around 30 minutes after turning off the car you should be fine. You don't need to disconnect the fuel rail btw. Just pull the injectors and lay the injectors/fuel rail over to the driver's side while you pull the intake. When you're done just flop the whole assembly back over.

 

thanks buddy, before i tore into the vehicle i wanted to make sure i was prepared with this area of the install. thanks a ton

 

No problem man. It's easier than you probably think. Can't wait to hear what you think of them. Did you get a tune for them?

 

Follow this and you'll be alright.
http://forums.bradbarnett.net/showthread.php?t=452819

 

Yeah, I used that same write-up and the install came out perfect.

 

yea, i have a brenspeed tune for the delete plates