Carmen Goudey Pulleys.
#1
Member
Thread Starter
Join Date: September 9, 2009
Location: Essex England
Posts: 32
Likes: 0
Received 0 Likes
on
0 Posts
Carmen Goudey Pulleys.
Ok, as some of you may know, I have been installing my TVS over the last couple of weeks. Alongside that, I have also been fitting a set of Carmen's pulleys, along with a custom made 3.75" pulley for the blower, to keep my boost at around the 8lbs mark.
For those of you who have not had the pleasure of dealing with Carmen, let me tell you that this is one of the most helpful and knowledgeable people I have ever dealt with. His attention to detail and customer service is second to non, and nothing was too much trouble in making sure that the correct parts were supplied to do the job properly.
The parts came well wrapped and clearly marked, along with a set of idiot proof instructions, clearly set out with step by step photo's.
So, on with the install.
The new pulleys, alongside the parts they were replacing...
Power steering pump pulley...
Pulleys going on...
Tensioner arm pulley
Quick change hub for blower pulley...
Blower pulley fitted...
Last of the idlers...
The finished article...
And the piece de resistance... (AKA the cherry on the cake)
Carmen actually made me two of these, the other one has a Union Jack in the centre rather than the TVS logo. I'm still not sure which of the two to use.
Once again thank you to Carmen for an awesome job.
For those of you who have not had the pleasure of dealing with Carmen, let me tell you that this is one of the most helpful and knowledgeable people I have ever dealt with. His attention to detail and customer service is second to non, and nothing was too much trouble in making sure that the correct parts were supplied to do the job properly.
The parts came well wrapped and clearly marked, along with a set of idiot proof instructions, clearly set out with step by step photo's.
So, on with the install.
The new pulleys, alongside the parts they were replacing...
Power steering pump pulley...
Pulleys going on...
Tensioner arm pulley
Quick change hub for blower pulley...
Blower pulley fitted...
Last of the idlers...
The finished article...
And the piece de resistance... (AKA the cherry on the cake)
Carmen actually made me two of these, the other one has a Union Jack in the centre rather than the TVS logo. I'm still not sure which of the two to use.
Once again thank you to Carmen for an awesome job.
Thread
Thread Starter
Forum
Replies
Last Post
swieduwilt
GT Performance Mods
21
4/19/06 09:09 PM