BMR LCA INSTALL HELP
#21
Yah, I would be worried that the metal insert (inside the bushing) being to short would cause the bracket ear's to compress to much and flex causing them to break over time. I would definatley swap them out. Did you remove both side's at the same time, thus the need for assistance??
#23
Just kick the axle a little till it line's up. Just don't kick it off the stand's then you will have more than a purple thumb... A helper is alway's good, but if your careful you should be able to do it yourself. "You can do it" in voice of wierd guy from the Water Boy...
#24
Shelby GT350 Member
Thread Starter
Join Date: October 4, 2004
Location: San Clemente, CA
Posts: 2,121
Likes: 0
Received 0 Likes
on
0 Posts
installed.
I don't notice a decrease in wheel hop. My car still burns out like crazy as I take off. maybe I am just tired. maybe its the new diablo program. I dunno.
going to bed. better analysis tomorrow.
I don't notice a decrease in wheel hop. My car still burns out like crazy as I take off. maybe I am just tired. maybe its the new diablo program. I dunno.
going to bed. better analysis tomorrow.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
2015 - 2023 MUSTANG
0
9/10/15 12:44 PM