BBK Cold Air Kit Install Question
Thread Starter
Member
Joined: September 16, 2004
Posts: 16
Likes: 0
BBK Cold Air Kit Install Question
I installed the BBK Cold Air Kit on my ’06 GT last night. The instructions say “The end of the air filter will act as an isolator between the inlet pipe and shield.” I can’t get the shield to slide over the rubber end of the air filter. The round hole in the shield seems to be too small to fit around the rubber end of the filter once the filter has been fitted onto the inlet pipe. Has anyone else had this experience, or do you have pictures of your installation? Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
Ecoboost
1
Jul 25, 2015 06:32 PM
