is there anyone out there who has installed cams in a 3 valve Mustang Motor or anywhere i can get info on install. Thank you

 

Try this...
http://home.comcast.net/~cookpaging/...otrodcams.html
Many people have done 3v cam swaps in their garage.

 

I installed my cams last month not sure what info you are looking for but if got questions im sure one of us with after markwt cams can help

 

Thats a great write up and the pics are extremely helpful.

 

I printed out the very good pics and instructions for our Mustang club President and he had already installed them. i told him it figures, lol. but i gave them to him. Thank you so much for the very well detailed instructions and pics. Dan Heagy former VP Mustang Club of Maryland.www.mustangclubofmd.

 

Haha. I used the same instructions BUT, for people with aftermarket crank pulleys (UD pulley people) The aftermarket pulleys aren't marked so finding top dead center is not easy.

What I did instead, was just start on cylinder 4, turn the engine over till the exhaust valve was close, remove the follower, look at cylinder 5, turn it over till the exhaust is closed, remove follower. And repeat for all the rest. You end up taking out more followers, but once you get the hang of it, it's easy so who cares. This method doesn't require finding top dead center, doesn't require turning it over a certain distance, then back again, but not too far, etc. You just keep turning it till the exhaust valve of each cylinder is closed, and remove the follower. Super easy.