G8 Atco Raceway video
Thread Starter
Mach 1 Member
Joined: May 18, 2007
Posts: 830
Likes: 0
G8 Atco Raceway video
http://www.fquick.com/videos/Pontiac_G8_Track_Run/5298
Stock: 2.03 60ft, 13.39 @ 104.7
After just tuning: 2.00 60ft, 13.10 @ 107.5
100hp nitrous: 1.96 60ft, 12.49 @ 114 mph
Not **** bad for a 4 door. They look alot narrower to me though than the cg pics.
A GXP with 403 HP, deeper gear, and manual should dip into 12 easily.
Stock: 2.03 60ft, 13.39 @ 104.7
After just tuning: 2.00 60ft, 13.10 @ 107.5
100hp nitrous: 1.96 60ft, 12.49 @ 114 mph
Not **** bad for a 4 door. They look alot narrower to me though than the cg pics.
A GXP with 403 HP, deeper gear, and manual should dip into 12 easily.
.
Of course, the same is true of the G8. Very impressive numbers that bode well (ominously?) for the Camaro, essentially a smaller, 2-door G8.
Thread Starter
Mach 1 Member
Joined: May 18, 2007
Posts: 830
Likes: 0
Heh ain't that the truth. Sad part is the more you make the more bills you acquire. 
.
Found on another forum
That six speed and independant rear sure sapped the hell out of some HP. 364 HP yet 279 RWHP. True enough it was a Mustang dyno though still not bad at all for an 87 octane tune to pick up that much RWHP.
. Found on another forum
Got to dyno a bone stock Pontiac G8 today. Nice car. Boy does GM cover their back-sides with all the timing reduction for temperature in coolant and IAT. Also very rich mixture.
Spent lots of time working on the tune since this customer would only run 87 octane. The results were very positive.
Baseline numbers were 279 rwhp, 299 rwtq
Tuned numbers were 313 rwhp, 328 rwtq
Because this tune was done on a Mustang dyno, we were also able to run the G8 on a 1/4 simulation.
Stock 1/4 mile dyno run: 13.44 @ 104 mph
Tuned 1/4 mile dyno run: 12.81 @ 109 mph
Tuned 1/4 mile dyno run with torque management removed: 12.49 @ 111 mph
Don't know how accurate the 1/4 mile dyno runs will be compared to the track, but a 13.44 @ 104 mph is not too far off of what stock G8s seem to be running. The owner plans on taking the car to the track soon so we'll have some real world results to back these up. Gotta love technology. We dropped nearly a second ET and we didn't have to turn a wrench.
I also made the AFM much more aggressive so the motor will cruise in 4 cylinder mode all the time cruising down the highway. I know this was good for a 2-3 mpg gain on my Suburban. I would expect similar gains on the G8. In this day of nearly $4 per gallon fuel, it's nice to gain over 30 rwhp and increase fuel economy at the same time.
Spent lots of time working on the tune since this customer would only run 87 octane. The results were very positive.
Baseline numbers were 279 rwhp, 299 rwtq
Tuned numbers were 313 rwhp, 328 rwtq
Because this tune was done on a Mustang dyno, we were also able to run the G8 on a 1/4 simulation.
Stock 1/4 mile dyno run: 13.44 @ 104 mph
Tuned 1/4 mile dyno run: 12.81 @ 109 mph
Tuned 1/4 mile dyno run with torque management removed: 12.49 @ 111 mph
Don't know how accurate the 1/4 mile dyno runs will be compared to the track, but a 13.44 @ 104 mph is not too far off of what stock G8s seem to be running. The owner plans on taking the car to the track soon so we'll have some real world results to back these up. Gotta love technology. We dropped nearly a second ET and we didn't have to turn a wrench.
I also made the AFM much more aggressive so the motor will cruise in 4 cylinder mode all the time cruising down the highway. I know this was good for a 2-3 mpg gain on my Suburban. I would expect similar gains on the G8. In this day of nearly $4 per gallon fuel, it's nice to gain over 30 rwhp and increase fuel economy at the same time.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
2015 - 2023 MUSTANG
0
Sep 24, 2015 08:15 PM
tj@steeda
2015 - 2023 MUSTANG
0
Sep 8, 2015 10:45 AM
