What parts are needed for rear bumper cover swap?
#1
Legacy TMS Member
Thread Starter
What parts are needed for rear bumper cover swap?
I think I'll just give in and buy a new rear bumper cover to replace the stock cover which was damaged.
What parts do I need to swap over a GT/CS rear fascia onto a 2007 GT?
Do I need anything (sidemarker reflectors, harnesses, retainers, etc...)?
Can I buy it from a parts dealer and then schedule a body shop appointment at the dealer? How much will this approximately cost? $300 for the cover, $200 for the paint? Is the rear diffuser on the GT/CS painted or just gray/black plastic?
This is what I have for part #s so far:
6R3Z-6320049-BA, GT/CS cover
Does anyone have a list of other parts I may need?
How about a part number for the stock 2007 Mustang GT rear bumper cover?
What parts do I need to swap over a GT/CS rear fascia onto a 2007 GT?
Do I need anything (sidemarker reflectors, harnesses, retainers, etc...)?
Can I buy it from a parts dealer and then schedule a body shop appointment at the dealer? How much will this approximately cost? $300 for the cover, $200 for the paint? Is the rear diffuser on the GT/CS painted or just gray/black plastic?
This is what I have for part #s so far:
6R3Z-6320049-BA, GT/CS cover
Does anyone have a list of other parts I may need?
How about a part number for the stock 2007 Mustang GT rear bumper cover?
#2
Legacy TMS Member
Can buy complete kit from Ford accessories thru local dealer, retails about 355.00, according to the Ford store website. Talk to the dealer where you purchased the car, he should be able to do cost plus 20%, if you are goig to have it painted and installed as same dealership (2hrs paint prep time, 1.5hrs remove/re-install). You can paint it anyway YOU want, Shelby is blacked out all around lower valance, GT/CS just rear center (between tail pipes)
Thread
Thread Starter
Forum
Replies
Last Post