wannabe shaker!!!
Thread Starter
Shelby GT350 Member
Joined: June 25, 2007
Posts: 2,416
Likes: 1
wannabe shaker!!!
V6 Member
Joined: October 14, 2007
Posts: 99
Likes: 0
Team Mustang Source
Joined: July 4, 2006
Posts: 2,872
Likes: 1
From: St. Louis Area
While I applaud them for trying to make a functional Shaker....this isn't really the best approach I don't believe. I'd have to see the airbox setup to decide if it could actually rob power, or provide about 2hp increase. Either way, it's not very good for power.
GT Member
Joined: August 3, 2005
Posts: 215
Likes: 0
From: S.C.
If CDC could do a kit like this, except with their cast aluminum scoop.
get rid of all the plastic, mustang plates and make a more economy priced kit I'd be all over that.
This is bad, but not as bad as that one that was offered by v6mustangstuff.com (the smokey and the bandit one). Looks like they took it off their webpage
get rid of all the plastic, mustang plates and make a more economy priced kit I'd be all over that.
This is bad, but not as bad as that one that was offered by v6mustangstuff.com (the smokey and the bandit one). Looks like they took it off their webpage
GT Member
Joined: September 7, 2007
Posts: 182
Likes: 0
the pj shaker is functional.....saleen suposedly designed it to where it could suc cold air from the shaker,instead of ram it down the stock air box and cause to much turbulance that robs power.
Mach 1 Member
Joined: September 10, 2006
Posts: 621
Likes: 5
From: Dallas, TX
While this particular system does look awful, you have to give some credit to someone trying to put together an affordable solution. Nearly $800 for the CDC system is just ridiculous. I would pay $350-$400 for a good shaker system, but CDC is not going to see any of my business at its current prices.
Tim
Tim
Team Mustang Source
Joined: January 29, 2004
Posts: 6,730
Likes: 3
