Mach 1 Chin Spoiler for '00 GT
#1
Anyone know about putting a Mach 1 Chin Spoiler on a 2000 Mustang GT? I'm seriously considering getting one as one of the few cosmetic items on my list. Would I have to get an entire front louve or would it just bolt on or something?
#2
it should come with a package of 15 or so plastic push pin type things. I taped my on with duct tape, took a drill and drilled out the holes, then just pushed those plastic pins in
I did it without a jack or ramps, just pulled my car up to the curb.
I did it without a jack or ramps, just pulled my car up to the curb.
#4
I Have No Life
Yeah..its hard to drill without jacking the car (of having a drop like that)
And rather than using all 15 push pins...I used 11 pins, and 4 bolts.
2 on the outer edges...and 2 near the center...
It ain't going ANYWHERE
And rather than using all 15 push pins...I used 11 pins, and 4 bolts.
2 on the outer edges...and 2 near the center...
It ain't going ANYWHERE
#6
Stubborn Bear
TMS Staff
TMS Staff
Originally posted by UA2k1GT@Apr. 21st, 2004, 1:20 PM
it should come with a package of 15 or so plastic push pin type things. I taped my on with duct tape, took a drill and drilled out the holes, then just pushed those plastic pins in
I did it without a jack or ramps, just pulled my car up to the curb.
it should come with a package of 15 or so plastic push pin type things. I taped my on with duct tape, took a drill and drilled out the holes, then just pushed those plastic pins in
I did it without a jack or ramps, just pulled my car up to the curb.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
2015 - 2023 MUSTANG
0
9/16/15 06:44 PM