finally gettin the chance to dyno my straight 6 '66 coupe after bein rebuilt a year or so ago...never been to a dyno or anything, any precatiouns or things i should do to her before i take her down tehre? any advice..thanks guys and ill let u know her numbers

 

They'll take care of all the safety precautions like strapping it down and stuff when it gets there.

Is your 6 stock or modded? Either way, I'm interested in what kind of power you are getting from the good ole straight 6

 

shes pretty much stock...bored 30 over...allnew stuff...ill let ya know...hope the other guys in my car club dont emarass me too much with their t/a's and cobras :-P

 

i'm guessing 85rwhp

 

Have you looked into the headers and 4bbl intakes they make for that motor? I'm sure that could let a few more ponies run wild. Not to mention the multitude of Aussie parts that exist speicifically to make this motor happy.

Can't wait to see where you go with this

 

well to make it a bad night...my timing was off and a vacuum hose had a crack in it so my car was barely able to run at an idle...and there were about 20 of us dynoing so i didnt have time or tools to fix her to get her strapped down darn it......so sorry guys no numbers for her...but we're goin again in the spring so hopefully then.....i might have to look into the headers and 4bbl intakes...any other suggestions of parts that'll make her moer happy? thanks guys

 

bummer man...I wanted to know too......Oh well...like you said...time for mods!

 

bet your lunch money it would have been less than 100

 

80 or 90, tops. I think... Clifford Performance, yeah. They make performance parts for the six-bangers.

 

clifford performance? has anybody used them before?