My 2013 GT's Older Brother
7/7/13, 07:36 AM
#23
Bullitt Member
Thread Starter
Join Date: August 9, 2004
Location: Mount Dora, Florida
Posts: 407
Likes: 0
Received 1 Like
on
1 Post
Cobra II Photos
Well, here she is! And not just a Mustang II with no engine, this little Cobra II has a built 302 pushing about 250 hp. I bet this would have made Farrah's hair a mess!!
7/20/13, 01:17 PM
#24
Bullitt Member
Thread Starter
Join Date: August 9, 2004
Location: Mount Dora, Florida
Posts: 407
Likes: 0
Received 1 Like
on
1 Post
New Cobra II Dash Trim
Not really installed completely as I have to refinish the bezel and eliminate the chrome around the guages. But I wanted to show the real metal trim I obtained to cover the original brushed aluminum which was really bad
7/21/13, 02:14 PM
#25
Bullitt Member
Thread Starter
Join Date: August 9, 2004
Location: Mount Dora, Florida
Posts: 407
Likes: 0
Received 1 Like
on
1 Post
Refinished Brushed Bezel
I picked up a bezel with the chrome/walnut trim from a 1975 Ghia and stripped it down, sprayed it matte black with 3 coats of matte clearcoat. Then I applied brushed aluminum vinyl to the steel panel I had cut and used 3M tape to adhere it to the bezel.
Here is my refinished bezel
Here is my refinished bezel
7/22/13, 06:42 AM
#29
Bullitt Member
Thread Starter
Join Date: August 9, 2004
Location: Mount Dora, Florida
Posts: 407
Likes: 0
Received 1 Like
on
1 Post
I used a Xacto knife and I used my steel trim as a template. Just went slow and took my time. The vinyl was purchased off of ebay at a small cost of $10 for a roll 12" x 60".
7/31/13, 01:08 PM
#30
GT Member
Join Date: July 30, 2013
Location: Iowa
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Rando
2010-2014 Mustang
8
8/25/21 11:12 AM