Sadly when I toss my VIN into most Ford part sites they can't find it. Having a hard time figuring out what the part number would be. Also the labels on it already worn off.

I found this for a 2012 but am not sure if they are the same for 2013:
Rockers

Or should I maybe look at aftermarket? If so, any suggestions? Not looking for anything crazy, just simple and nice looking

Quick story:
Got in a fight with some snow (apparently ice) built up along the side of the road when I went to make a turn...ripped the driver side skirt right off


Pics:

 

I believe you might be better off with this
http://www.fordparts.com/Commerce/Ca...Mustang#Search

 

10176!

 

Ah that site does work! It wasn't loading for me at all yesterday. Thanks!

 

The 2013 mouldings are paint to match and the LH part number is DR3Z-6310177-AA and MSRP is $276.38 or you could buy the 2012 black mouldings that are not paint to match. The 2012 moulding MSRP is $134.48 for either side as found on your link to fordpartsoem.com and the part numbers are BR3Z-6310176-AB (RH) and BR3Z-6310177-AB (LH). The 2012 mouldings have a nice scallop in them that was eliminated for 2013.

 

I'd fasten that side skirt back on using nylon retainers. Meanwhile I'd wait until all the snow was gone to pop new fresh one(s) on.

Why beat up the new skirt all over again?

 

Hmm interesting, thanks for all of the info! Tousley has the 2013 ones for $180 which is what I will probably go with

getportfolio: its pretty badly scraped up and a lot of the holes are cracked from being ripped off. Weather has already started turning, I think we are pretty much done with any decent amounts of snow. Though this is Michigan...you never know

 

You can get the unpainted ones for $88 from Levittown and add the roush splitters. That would look great as far as contrast on your white car.

 

are those prepainted?

 

I don't think so. I just typed in the part number listed above. I would think that the unpainted would look good with the roush splitters.

However, I know that the OP may want the original back. It just seems pricey.. You think ?

 

No, sorry; paint to match.

 

Dang. I saw a guy that put 11-12 side skirts on his 05-09. It looked great with the side splitters, but it was Unpainted and I want painted. I really want splitters on mine. I know they will work but I'll have to cut the tabs off. Hmm I dunno! Always something to have on the list

 

Grrr.... I ran into the issue my self too... Today while pulling in a driveway that had rocks/gravel my right tire fell in a deeper end which i did not see... and scratched my ( passenger right side skirt ) I AM SO PISSED... I hope doctor chip works, is it even worth picking up one for 280 from ford?

What does it mean paint to match? Do i have to paint it my self? I will take a pic and show you guys, and then if you can give me your opinion....