Grille swap from pony package to performance package
9/26/12, 08:42 PM
#1
Mach 1 Member
Thread Starter
Join Date: May 3, 2012
Location: NJ
Posts: 748
Likes: 0
Received 0 Likes
on
0 Posts
Grille swap from pony package to performance package
Hey all,
I just got my performance package grille today for my '13 and I tried to install with the "yank as hard as you can until the grille pops out" method, but wasn't able to pull the grille out. Is there a secret to doing it this way? Would it be easier/faster/safer to just take off the bumper?
I know there is a recent post about grilles, but that one focused on the Roush grille, which has clips that need to be attached from the rear.
Any advice would be greatly appreciated!
I just got my performance package grille today for my '13 and I tried to install with the "yank as hard as you can until the grille pops out" method, but wasn't able to pull the grille out. Is there a secret to doing it this way? Would it be easier/faster/safer to just take off the bumper?
I know there is a recent post about grilles, but that one focused on the Roush grille, which has clips that need to be attached from the rear.
Any advice would be greatly appreciated!
Last edited by Dfink114; 9/26/12 at 08:46 PM.
Thread
Thread Starter
Forum
Replies
Last Post