I have a 2013 Black GT Mustang Premium coupe with the MT-82 transmission, electronics package and 3.73 gears out back. Mods and accessories as of today:

- OEM Back up camera and spoiler installed
- Classic Design Concepts Shaker Hood
- 1970 Mach 1 hood Strip and rear black out panel Flat Black
- Blowfish Racing Shifter Support Bracket
- Barton Short Throw Shifter
- Boss 302 Shifter ****
- Boss 302 Staggered 19" Wheels with Goodyear Eagle F1 Asymmetrical All-Season
- GT500 Steering Wheel
- GT500 Alcantara Suede Shift Boot
- GT500 Alcantara Suede Parking Break Boot
- Brembo brakes with performance pads and drilled and slotted rotors
- SVT Mach 1 Faux Gas Cap Emblem
- Tinted Windows
- OEM All-Weather Floor Mats
- iPod hooked into 2nd Sync plug behind the Glove box

If you have any question about my car or myself feel free to ask, I'm always up to help a fellow Mustang enthusiast. Sorry for the picture quality, I took the photos with my phone next time around I'll bring out the good camera.

 

Nice! Good start on the mods and I like your Mach 1 theme you got going.

 

Thanks, my first love was a 1969 Mach 1 Mustang 1/24 Revell model and I was hooked from that point on. The way I look at it is the S95 are like the 64' 1/2 to 66' Mustang small but a hell of a lot of fun. Then the S195 are like 67' to 70', 05' to 09' are 67' and 68' and 10' to 12' are 69' and the 13' and 14' are the 70' Mustang. The Shaker hood looks okay on the S95 when they made the Mach 1s in 03' and 04' but it just looks right on the 05' to 12's and amazing on 13' and the 14's. Just my way of looking at things.

 

Looks great. Love the Boss wheels and the stripe!

 

Nice car. Interested in OEM Backup Camera, how was the install and how much did it cost?

 

The install wasn't to bad, I have the factory Nav so I just bough the pigtail for the camera, the spoiler and camera, and some 16 gauge shielded wires if I remember right it's has 4 wires in it and then used the wiring diagram to figure out the pin out on the connector the hooks into the dash harness. I also had to use my Ford VCM II to change the body control module to a car with nav and back-up camera. All in all, I'm in it for $250, $220 for the spoiler and camera (ebay it was a New Take Off from Roush), $14 for the pigtail (bought it from the local for dealership part number WPT-1130 or AU2Z-14S411-BNA) and $16 for the 16 gauge shielded wire.

These helped me a lot and I would like to thank apial and DeeJayTJ for the great work. The only thing different I did was use the factor camera instead of an aftermarket one and the factory Nav.

HOWTO: Aftermarket Backup Camera on OEM Navi WITHOUT using Lockpick

Added factory camera spoiler to Base Model

 

The camera spoiler is one of the best looking. Great all around car.

 

Love the wheels.