I need some sheet metal scrap to close some 'holes' and fab an instrument panel in my track car...the major piece needs to be a min of ~24"*36". Pretty much any thin steel or aluminum would do-if you have some, I'll make it work.

Any one have some scrap laying around? For such a piddling amount I dont really want to pay a metal vendor serious $$$$ for a 'new' sheet.

I pay in thanks, "wrench" labor, N.A.S.A. goodies, beer, or a Jackson or so, depending on your preferences


Thanks!

 

Hey Eric, We have a couple of old hoods that are fairly flat that you could cut some pieces out of. Come and get it. TTYL, Greg

 

thanks Greg, Ill give you a holler soon as I can

 

i may have a piece of 0.40 T6 24 x 48 sheet i can part with ... i will check and let you know..

 

operators are standing by!

 

i can bring you a piece to the DQ tomorrow nite... it`s more like 36 X 72

 

Hey Hoss, I am looking at building an aluminum air cleaner assm to seal to the bottom of my hood. I am trying to capture only cold air from the hood scoop on my Dakota. Can you get aluminum that is fairly thick (1/16th) but still bends easily? I can get aluminum sheets from our trailer shop but it breaks when you bend it too far.

 

Sorry, I was out of town last night....shoot me an addy and I'll come by if you like, or any other method you prefer.

 

A BIG thank you to Hoss for helping me out on this! Just wanted to post my appreciation for assisting me with the metal, thanks!!