Redfire with Black Stripes
The following users liked this post:
Mustang_Ed (3/21/21)
#3
#4
Mach 1 Member
Join Date: July 16, 2004
Location: Greenfield In.
Posts: 851
Likes: 0
Received 0 Likes
on
0 Posts
I also have a Redfire 05 and was thinking about black stripes. I have seen both black and silver stripes and I have to say its a tough decision. Black looks real racey but silver seems to blend well with the deep dark Red too. Post pics if you got them!
The following users liked this post:
Mustang_Ed (3/21/21)
The following 2 users liked this post by usmcnam68:
John Gibb (4/12/21),
Mustang_Ed (3/21/21)
#12
Join Date: May 27, 2007
Location: Tulsa Area
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
#13
You betcha!
Take a look at this thread in the California Special section, there are some pictures with the stock wheels and then another set with Magnum 500 wheels a little further down.
http://forums.bradbarnett.net/showthread.php?t=461958
Last edited by CaliforniaShaker; 3/12/08 at 10:10 PM. Reason: Thread number in link changed
#15
Mach 1 Member
hey californiashaker, where did you get the license plate holder on the front and does it fit just the regular GT bumpers too? maryland requires a front plate also (even though i havent put it on yet in over 2 years!) i might have to since they are cracking down here. yea, im all the way on the east coast...thanks!
#16
hey californiashaker, where did you get the license plate holder on the front and does it fit just the regular GT bumpers too? maryland requires a front plate also (even though i havent put it on yet in over 2 years!) i might have to since they are cracking down here. yea, im all the way on the east coast...thanks!
That's actually the factory plate holder. I'm not sure if it'll fit on a standard GT but the bumpers are different so I kind of doubt it'd be a direct fit. I bet you could get one and do a little cutting on it to make it fit though.
#19
I think it would depend on what other mods you have in mind. On ours I went with the matte in order to match the CS striping. I think either would look good though as long as everything is consistent.
#20