PSH Update: Work Begins on Foose Hood
#1
The Mustang Source FOUNDER
Thread Starter
Join Date: January 29, 2004
Location: Vestavia Hills, Ala.
Posts: 9,887
Likes: 0
Received 11 Likes
on
10 Posts
PSH Update: Work Begins on Foose Hood
Paul "svopaul" Becker of Special Vehicle Productions has begun priming the Chip Foose hood for installation on October 16. Paul will also be installing the CDC Shaker and Legend Chin Spoiler.
#3
Cobra Member
Join Date: April 7, 2005
Location: Holland
Posts: 1,452
Likes: 0
Received 0 Likes
on
0 Posts
I've been waiting to see the CDC shaker + Foose hood combo on a car other than that on CDC's website. I'm sure it's going to look great!
One question for Brad: how do you plan to adapt the CDC shaker to the Vortech air intake?
One question for Brad: how do you plan to adapt the CDC shaker to the Vortech air intake?
#4
The Mustang Source FOUNDER
Thread Starter
Join Date: January 29, 2004
Location: Vestavia Hills, Ala.
Posts: 9,887
Likes: 0
Received 11 Likes
on
10 Posts
It's going to take a little fabrication, but I've seen SVPU's work and I know it won't be a problem. The upper air tube that comes attached to the Shaker can be used, but we'll have to fabricate some ducting to extend from the Shaker's ducting to the blower's filter.
#13
The Mustang Source FOUNDER
Thread Starter
Join Date: January 29, 2004
Location: Vestavia Hills, Ala.
Posts: 9,887
Likes: 0
Received 11 Likes
on
10 Posts
It's not at the moment. SVPU is backed up right now, so PSH is getting pushed back a week or two. The new Steeda GT500 shifter shipped yesterday and I'm going to get the transmission next weekend.