This 1999 Mustang Grille Emblem should work well for The Repo Engine cover. As long as it is not to thick you could drill some holes and attach with the studs and some tinnerman clips. {shown} The Gt emblem is shown for Scale. Thanks to Nick Adams out of Kansas for Ordering these for that purpose! Came in today Going Out tommorrow! Had to get a shot for TMS! These would also be cool on other Areas.


kc
[attachmentid=17759][attachmentid=17760]
[attachmentid=17761]

 

That's awesome Kevin. I also think the Explorer's V8 badge would look cool on that engine cover.

 

Got a pic?

 

2.5" tall, 1.5" wide

 

Nice... I have to agree with you there, Brad.

 

I keep These Ponies in Stock and throw in the Tinnerman Clips for Attachment!

kc

 

New to the boards here although I've been lurking for months. I was more of a diesel junkie until the new stang came out then I told my wife it was time for my midlife crisis. I got the plenum cover from midwest and put on a 1968 mustang grille emblem and some Ford lettering. It also attached with the clips so I had to drilll some holes which wasn't a problem but the studs on the emblem were long enough that the cover wouldn't seat all the way. I had to grind down the studs a bit, turned out OK I think. Haven't figured out how to post a pic yet so I'll link to my webshots album.

Great site and you guys are a wealth on info, you're just as proficient at spending my money as the guys on the diesel forums

Plenum Cover

 

$$$$$$$$$ . . . .

 

I have a Corral of these! WILBER!!!!!!!!!!!!!!

 

I've got a 99 on mine too.

But, I used the High-Heat glue method.

Been holding fine for about 2 x months now.

Tom

 

Thanks for the photo of the Plenum cover with the Steeda strut brace! You've answered a burning question concerning the clearance.

 

Refresh

For Current hotsheets email clevparts@aol.com