View Poll Results: Which would go best with my Car?
SSE Gen 1 Rear Valence



5
27.78%
Shelby GT 500 Rear Bumper



13
72.22%
Other (post below)



0
0%
Voters: 18. You may not vote on this poll
SSE Gen 1 Rear Valence or Shelby GT-500 Rear Bumper.
SSE Gen 1 Rear Valence or Shelby GT-500 Rear Bumper.
I plan on adding a SSE gen 1 v6 front bumper and Shelby GT-500 rear spoiler to my car soon (I already have a Steeda Cowl Hood and I'm undecided on any side skirts atm ). I wanted some opinons on what would go best with this setup.
I just made this decision as well. I had my mind set on the SS rear lip until the GT500/CS rear bumper came out. For only about 40 bucks more you get a full bumper and the lines run smoother with the car than the SS one. You'll also always have a seem with just the lip. Those are the reasons I'm getting the GT500 bumper instead of just the SS lip. Maybe if I had the whole SS kit I would stick with the lip though.
After looking at them for hours on end we decided on the GT 500 bumper too. It just flows well with the car and I think it'll fit in with what I'm looking to do. I'm probably going to leave the side skirts stock for a bit then maybe the 3d carbon ones (not the boy racer ones) as they have a nice OE look to them. Sucks winter is coming up
but I'm going turbo next summer
cant wait! Thanks again guys.
Originally Posted by Shaun81
After looking at them for hours on end we decided on the GT 500 bumper too. It just flows well with the car and I think it'll fit in with what I'm looking to do. I'm probably going to leave the side skirts stock for a bit then maybe the 3d carbon ones (not the boy racer ones) as they have a nice OE look to them. Sucks winter is coming up
but I'm going turbo next summer
cant wait! Thanks again guys.
Thread
Thread Starter
Forum
Replies
Last Post



