Sequential Taillights with Shaker 1000
#1
Thread Starter
Team Mustang Source
Joined: December 13, 2004
Posts: 778
Likes: 0
From: Sterling Heights, Michigan
I ordered the Webelectric sequential taillights (can't wait!).
My question is, I also have the Shaker 1000. I've read in some other posts that to install the replacement right-side taillight harness, I'll have to remove the Shaker 1000 enclosure (at least partly).
For anyone who's done this, could you please let me know how I get the Shaker out of the way?
Thanks for the help!
My question is, I also have the Shaker 1000. I've read in some other posts that to install the replacement right-side taillight harness, I'll have to remove the Shaker 1000 enclosure (at least partly).
For anyone who's done this, could you please let me know how I get the Shaker out of the way?
Thanks for the help!
#6
Thread Starter
Team Mustang Source
Joined: December 13, 2004
Posts: 778
Likes: 0
From: Sterling Heights, Michigan
Thanks everyone.
I was going to move the Shaker, but couldn't get one of the bolts to loosen (didn't want to strip it).
So I managed to do it without removing the Shaker... very tight, but got it after a while.
I had a nice surprise on the left side... there was a rubber grommet on both sides of the body... the one on the inside was basically attached to the harness (the right side didn't have one on the inside). That was odd.
Anyway... the install went great. They make a huge difference!
I was going to move the Shaker, but couldn't get one of the bolts to loosen (didn't want to strip it).
So I managed to do it without removing the Shaker... very tight, but got it after a while.
I had a nice surprise on the left side... there was a rubber grommet on both sides of the body... the one on the inside was basically attached to the harness (the right side didn't have one on the inside). That was odd.
Anyway... the install went great. They make a huge difference!
Thread
Thread Starter
Forum
Replies
Last Post