GT300 Stripes from graphic express.com
#5
Bullitt Member
Thread Starter
Join Date: January 9, 2005
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
If you've never done it before it stinks... Once you know how, its kind of easy... the secret it lots of fluid and a lot of patience... most of all follow the instructions....
#9
First off. VERY nice job on the stipes. I will do the same to my '06. However! I have a real problem with the GT badge on the fender and the repeating of the GT in the stripe (GT 300). I would prefer NO badge on the fender, but as we all know, there are pilot holes which will not go undetected. Maybe the pony with the tri-bar??
I do prefer the GT in the stipe, tho. VERY NICELY DONE...
I do prefer the GT in the stipe, tho. VERY NICELY DONE...
#10
I think it would look better with just the white stripe,sans the "GT300"; it's redundant,IMO, to have the GT emblem above and then "GT300" on stripe just below...sorry,I think it clashes.
#15
Kevin I think you will like the GT300 stripe in metallic silver on the WB. Of course I'm prejudice - my car is the one on Graphic Express' web site. When finished I have the GT300 rocker stripe and Lemans stripes in silver metallic. I think they look excellent!
#17
Team Mustang Source Legacy Member
Originally posted by tricksixtyfive@February 15, 2005, 8:25 PM
I personally think it wouls of looked better a little lower..like the top stripe the only on on the door
I personally think it wouls of looked better a little lower..like the top stripe the only on on the door
But I still think they look good.
#20
Bullitt Member
Thread Starter
Join Date: January 9, 2005
Posts: 350
Likes: 0
Received 0 Likes
on
0 Posts
The cost was like $89.00 total... I have a couple of "small" wrinkels in the passenger's side door... I'm hoping the sun and time will work these out.. They did come out when I did my now gone 03 vert...