And this is the tird forum i my letters will be seen on

Here you go. Hope you all like em!

http://putfile.com/pic.php?pic=6/16714175258.jpg&s=f5

http://putfile.com/pic.php?pic=6/16714115185.jpg&s=f5

http://putfile.com/pic.php?pic=6/16714094438.jpg&s=f5

http://putfile.com/pic.php?pic=6/16714073231.jpg&s=f5

Endemo

 

Very nice!

 

I love the MUSTANG along the trunk line yet my mind is still out on the FORD lettering. I may have opted for the blue oval on the sides, but my car is white and with the Black your choice of chrome letters a better solution. Definitely going to see more cars with MUSTANG on the trunk lid though!

 

+1

Where did you get the letters?
They look sharp.

 

Looks good!

 

CJ Ponyparts "EMPL 64-70 MUSTANG PIN LETTER SET" 8,95$ a set. I am not sure if they got a "stick on" set too thou. I had to chop the pins and grind the pin remainings. Afterwards i had to paste 3M adhesive tape. Was a bit complicated cause the letters are fairly small. But if you take your time it works really well.

Endemo

 

The "FORD" looks kind of 'old school - hummmmmmm, maybe something I sould do later? Kind of up in the air for me, but it does look pretty good on your car. At least different.....

 

Thats unique. Great job.

 

Car looks darn good!

 

Nice job - looks good!

 

Tahnks for the great feedback guys!

 

Woooooa!Nice!Though not sure on the Ford on the fender.Guess I'm just used to the Mustang fender letters.
That grill looks awsome too!

 

I like the lettering across the trunk. Hey Endmo, where in Germany are you?

 

Yup, same deal, went to Carlisle, but made a stop @ CJ Pony Parts in Harrisburg, awesome place and tons of mustangs and parts there, unbelievable, guys there are awesome, but the same kit for $18.95, says its from a 68-71 Mustang. and here they are a few weeks later after installation..

 

How did you remove the side GT Emblems, were they glued on?

 

hair dryer and a credit card. took me a while because they are held on by very very strong double sided adhesive. but i finally got them off and got the tape residue off with some WD-40. worked great.

 

That looks great. I like that.

 

Love ther rear MUSTANG lettering. Not sure about the FORD fender letters.

Love the grille! I'm getting the same one for my GT, just blacking out or cutting out the mesh parts. Did it install easily?

 

Use a hair dryer and fishing line. Or in my case, tooth floss since I didn't have any fishing line and was othewise occupied to go get some. Worked great...

 

I am in a smaller town named Hanau. Close to Frankfurt am Main.

@Warbird 69 no big deal if you take off the complete frontbumper. Easier to come by to the lower grille insert wich is a pain to remove with an installed frontbumpercover. No fear, the bumpercover is removed with only 4 screws.
Concerning the grille insert: You should consider just buying some aluminium or stainless steel mesh and just paint it if you want it blacked out. The mesh that comes with the grille is only chrome plated steel wich started to rust very quick on mine. The ceiling is stainlessstell and really good quality.
I payed 10 Dollars for my aluminium mesh.

Endemo