So still not as good as the last set, but I really didn't have the time to drive around and find a great place. It's better than my driveway The lighting today was terrible, so searching out a great spot would've been a waste of time.








And here's one for Marcello. An updated lower grill shot with the new upper grill.

 

Sure looks great! You may have sold me on those mirrors! Did you just ask them to just paint the "head" part? I noticed on their site the entire thing is painted.

 

I asked for just the mirror housing, to be red The rest was painted black. To make it look right, they have to paint the black part, too. It's $125 extra. If you want to get some done, email them here at Customersvc@SilverHorseRacing.com Since it's custom, it will take some extra time.

 

thanks!!

 

man those are awesome photos......

i gotta get those mirrors

 

Now those all look great! Props man! Nice looking ride!

-danny

 

Looks so clean. I dont know what your talking about the pictures look awsome!

 

Nice Ride! just enough black to offset the Red to make it look racey and tough. I like those "Bullitt" mirrors too. I call them bullitt cause the have the bullit nose on them.

 

Very tasteful, very clean. Good job.

And good choice in aftermarket products, if I do say so myself

The tire size definitely helps out to fill the wheelwell without being overly large. I still vote it needs the splitter, but now we're in the 4-5 week backorder range on them.... but it or another smal black front one would realy carry the red and black theme to a nice conclusion on the front of the car.

I should take some new shots for you of the rear CS bumper we added to ours recently. I wasn't a fan of them until it was installed, then it just hit me that it really can clean up the back of the car and break up the "junk in the trunk" look these rear bumpers tend to have...

 

Lol that's funny, because I plan on doing a CS rear bumper. I plan on doing a front splitter, too. Even after our discussion the other day, I'm still going back and forth between the Legend splitter, and the CDC classic painted GT/CS style. That would tie the theme together also.

 

I hate you... now not only do I have to buy a new suspension set up but now I have to get those **** mirrors too!! Marcello you will be hearing from me in approximately 2 paychecks lol. Simply awesome man your car is looking mighty fine if you ask me.

 

You know I didn't even see the caption on the last shot - we actually carry those grills now. I have a few hiding in the back warehouse

 

Do ya'? I might need a new one. Got this POS from Blue Oval Industries. Supposed "no modifications necessary". Tell that to my radiator support. It also has no pliability to it at all, and so one of the mounting tabs broke during installation. It also has a bit of a wave in it. I didn't want the 3D Carbon one because that put the fogs too close together. I thought I was buying the Street Scene grill. But I think this is what's referred to as the KSR grill. It sucks.

 

I don't have a factual report on the SS piece, as we haven't installed one ourselves yet here, but that is what we are stocking.

They are made in Taiwan, but the tool it was created on looks nice (ie part looks well done). I don't know what material was used (it doesn't look like what we use - more than likely it is a standard black ABS) so it is a little more rigid, but I doubt it will be a problem on the car where it is, unless the sun attacks it long-term. (No way to tell if UV resistant resin was used or not by looking).

On edit - the way the "made in china" stuff goes, they both might be the same part - hard to say unless you could remove it and take a picture of the center bottom area where the tool is engraved - then we could tell if they are one in the same. Another reason why we make all of our parts here

Anyway, they are here, and as usual nobody has time to put them up on the web Maybe when our new guy starts next month, or our new office assistant who starts in May after our move...

 

Should hire me to do your website. Maybe my photos would finally show up in the customer cars section.

My radiator support has already been modified. I'll just be more careful with install. If it's the same one, at least I'll be buying it from you.

 

Wow, looks great. Killer mirrors, never really liked them but they look smokin' on your car. The other accents (louvers, gas cap) look great too- nice job.

 

BTW, the answer is yes - send the high-res shots! Need a 3/4 rear of the driver's side from a little higher and a little more to the side, would go real nice...

 

Ok. Next photoshoot I'll make sure to get one. Like this, or a little more rear?

 

No, that's perfect Just needs the mirrors installed...

 

Looking good!