underdrive pullies gotta go... how hard?
Thread Starter
Cobra Member
Joined: July 27, 2004
Posts: 1,292
Likes: 2
From: Bakersfield, CA
underdrive pullies gotta go... how hard?
So I'm making the jump to a whipple and I naturally want to lose the underdrive pulley in favor of the stock item. I think I remember this is a bit of a pain in the ****. Anyone want to clue me in?
Team Mustang Source
Joined: November 13, 2004
Posts: 1,051
Likes: 0
Lucky you! I just finished my Saleen install and thus had to remove my UDPs. It's no different than the install.
Then follow TacoBills how to for installation of the stock pulleys.
- Get a new crank bolt from ford
- Get your breaker bar and your torque wrench.
- Loosen all of your bolts before taking the belt off
- Take the belt off
- Take the water pump pulley off
- Put your 3 ARM (not 3 jaw) pulley removal tool on the crank pulley (leave the crank bolt in there)
- crank away until everything is off
Then follow TacoBills how to for installation of the stock pulleys.
Thread
Thread Starter
Forum
Replies
Last Post
Gigantor
2005-2009 Mustang
31
May 11, 2023 07:31 PM