08 GT/CS

Well it lasted 3 months and I have to start modding..... installing some Pypes Violator axle backs next week, is it as easy unbolting the clamps and pulling the mufflers off the hangers ? Anything special in the re&re?


Thx

Glenn

very easy. Line up the tips before you tighten every thing back up.

Reminisce

One of the stock mufflers (cant remember which one, did mine 2 years ago) is a pain in the rear to get off for some because of one of the bolt locations. Just be patient and you can get to it.
The installation of the new mufflers, however, is easy as cake. And like Glenn said, make sure you line up the tips before you tighten the last few bolts.

adrenalin

Like Reminisce said, one is a pain....the drivers side. However it should take you about 30-45 minutes to swap them out.

tom281

Easy install, follow these guy's advice and you'll be fine.

8905GT

Mine was a pain because the brackets did not line up and it was hard to get the muffler tips centered. I still need to redo one of them. Good luck!

08 GT/CS

Thanks guys

GOarmy08

Yeap... driver's side was a pain... Try to not get too frustrated. lol. I also had a 1/2" trimmed off my mid-pipe by a pro-exhaust shop because I thought the MAC's stuck out a little too far.

Modded '08s... that's what I'm talking about. haha.

nm3

You waited 3 months before the first mod? I couldn't wait 2 days and my FRPP Stingers were on the car. Modding is a disease that has no cure! Have fun!

08 GT/CS

yeah once you start...... CAI & tune are looking good, gears.... **** here we go again

8905GT

I am working on a cure for this mod disease but I am running low on funds. Please donate so we can find a cure, its a good cause, come on people!
PM me with details to send your money to!!!!!