Blown Baffle in my Flowmaster Muffler
6/20/07, 09:09 AM
#22
Cobra Member
Join Date: July 29, 2004
Location: SoCal
Posts: 1,447
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for all the info.
A couple of more questions though.
1. I dont know if I can find my original receipt. Will they still replace?
2. Do I have to ship them back first and then they send a replacement set?
3. Can a local authorized dealer verify the problem and give me a replacement and facilitate the exchange?
A couple of more questions though.
1. I dont know if I can find my original receipt. Will they still replace?
2. Do I have to ship them back first and then they send a replacement set?
3. Can a local authorized dealer verify the problem and give me a replacement and facilitate the exchange?
2. No they ship first and have you reuse the same packaging to return them.
3. That's what I did. My local muffler shop took a look at it, I was hoping it wasn't a cat. They were able to figure out it was a bad weld. But they couldn't give an exchange. It has to come from the corporate office.
6/20/07, 05:55 PM
#25
Thread Starter
Join Date: October 13, 2006
Posts: 2,246
Likes: 0
Received 0 Likes
on
0 Posts
Ok I talked to FLowmaster and Basically your SOL if you don't have that receipt. However I have a local muffler shop that is a flow dealer and they are going to see if they can do somthing for me. I hope they can. I hate the buzzing noise!
6/20/07, 09:00 PM
#26
GT Member
Join Date: November 6, 2006
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
have the same problem
Look for my post with a vid of what you are describing. I made a vid today showng the O/R x pipe flowmaster and vibrant resonator set up and I noticed it when I watched the vid. LOOK FOR MY POST
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
2015 - 2023 MUSTANG
0
9/10/15 12:44 PM