Hello from Iraq.
What's up everyone,..I decided to register cause the love of my life is so I thought it was about time I did. My name is Ryan and I am currently serving in Iraq for a second time with the 3rd Infantry Division from Ft. Stewart, Ga. I drive an oxford white 2004 cobra. I hang around www.modularpowerhouse.com most of all, plus that is where my car is currently. Don't have my new dyno numbers with the mods below, but I will in a few weeks. My old numbers are 465/487. My current mods are:
SCT 4-bank chip w/custom Cobra Killer tune.
Engine:
Spec Stage 3 Clutch
Spec Steel Flywheel
NGK spark plugs
Power Adder:
Kenne Bell 2.2 Twin Screw Supercharger
Richard Racing blower pulley
Metco 100mm idler
Air/Fuel:
Steeda CAI
Kenne Bell boost-a-pump
60LB injectors
Exhaust:
Dr. Gas x-pipe
Borla stinger cat-back w/ 4" tips
Drivetrain:
Hurst line lock
Steeda Tri-ax
Cooling:
Gords Heat exchanger
Canton Coolant expansion tank
Canton Intercooler expansion tank
Suspension:
Front:
Steeda Sport Springs
Rear:
Steeda Sport Springs
Maximum Motorsports full length subframe connectors
Horsepower by Hermann adjustable shocks
Guages/Pods:
Autometer steering column bezel
Autometer Triple A-piller
Autometer guages-Boost/Fuel pressure/Water temp
DynoJet Wideband Commander
Raptor shift light w/Red LED
Wheels/Tires:
Street
Front-17x9 Eagle F1 275/40ZR17
Rear- 17x10.5 BFGoodrich T/A KD 315/35ZR17
Drag Strip
Front- 15x3.5 Weld Draglites,
Rear- 15x10 Weld Draglites, 15x10x26 MT E/T streets
Well looks like a cool site and I hope to chat with some of you soon. Later.
--Ryan (a.k.a bub)
SCT 4-bank chip w/custom Cobra Killer tune.
Engine:
Spec Stage 3 Clutch
Spec Steel Flywheel
NGK spark plugs
Power Adder:
Kenne Bell 2.2 Twin Screw Supercharger
Richard Racing blower pulley
Metco 100mm idler
Air/Fuel:
Steeda CAI
Kenne Bell boost-a-pump
60LB injectors
Exhaust:
Dr. Gas x-pipe
Borla stinger cat-back w/ 4" tips
Drivetrain:
Hurst line lock
Steeda Tri-ax
Cooling:
Gords Heat exchanger
Canton Coolant expansion tank
Canton Intercooler expansion tank
Suspension:
Front:
Steeda Sport Springs
Rear:
Steeda Sport Springs
Maximum Motorsports full length subframe connectors
Horsepower by Hermann adjustable shocks
Guages/Pods:
Autometer steering column bezel
Autometer Triple A-piller
Autometer guages-Boost/Fuel pressure/Water temp
DynoJet Wideband Commander
Raptor shift light w/Red LED
Wheels/Tires:
Street
Front-17x9 Eagle F1 275/40ZR17
Rear- 17x10.5 BFGoodrich T/A KD 315/35ZR17
Drag Strip
Front- 15x3.5 Weld Draglites,
Rear- 15x10 Weld Draglites, 15x10x26 MT E/T streets
Well looks like a cool site and I hope to chat with some of you soon. Later.
--Ryan (a.k.a bub)
:cheer: you're here!!
warning: we enduce vomit with our gheyness
warning: we enduce vomit with our gheyness
Originally posted by KB22Cobra@December 19, 2005, 6:19 PM
What's up everyone,..I decided to register cause the love of my life is so I thought it was about time I did. My name is Ryan and I am currently serving in Iraq for a second time with the 3rd Infantry Division from Ft. Stewart, Ga. I drive an oxford white 2004 cobra. I hang around www.modularpowerhouse.com most of all, plus that is where my car is currently. Don't have my new dyno numbers with the mods below, but I will in a few weeks. My old numbers are 465/487. My current mods are:
SCT 4-bank chip w/custom Cobra Killer tune.
Engine:
Spec Stage 3 Clutch
Spec Steel Flywheel
NGK spark plugs
Power Adder:
Kenne Bell 2.2 Twin Screw Supercharger
Richard Racing blower pulley
Metco 100mm idler
Air/Fuel:
Steeda CAI
Kenne Bell boost-a-pump
60LB injectors
Exhaust:
Dr. Gas x-pipe
Borla stinger cat-back w/ 4" tips
Drivetrain:
Hurst line lock
Steeda Tri-ax
Cooling:
Gords Heat exchanger
Canton Coolant expansion tank
Canton Intercooler expansion tank
Suspension:
Front:
Steeda Sport Springs
Rear:
Steeda Sport Springs
Maximum Motorsports full length subframe connectors
Horsepower by Hermann adjustable shocks
Guages/Pods:
Autometer steering column bezel
Autometer Triple A-piller
Autometer guages-Boost/Fuel pressure/Water temp
DynoJet Wideband Commander
Raptor shift light w/Red LED
Wheels/Tires:
Street
Front-17x9 Eagle F1 275/40ZR17
Rear- 17x10.5 BFGoodrich T/A KD 315/35ZR17
Drag Strip
Front- 15x3.5 Weld Draglites,
Rear- 15x10 Weld Draglites, 15x10x26 MT E/T streets
Well looks like a cool site and I hope to chat with some of you soon. Later.
--Ryan (a.k.a bub)
What's up everyone,..I decided to register cause the love of my life is so I thought it was about time I did. My name is Ryan and I am currently serving in Iraq for a second time with the 3rd Infantry Division from Ft. Stewart, Ga. I drive an oxford white 2004 cobra. I hang around www.modularpowerhouse.com most of all, plus that is where my car is currently. Don't have my new dyno numbers with the mods below, but I will in a few weeks. My old numbers are 465/487. My current mods are:
SCT 4-bank chip w/custom Cobra Killer tune.
Engine:
Spec Stage 3 Clutch
Spec Steel Flywheel
NGK spark plugs
Power Adder:
Kenne Bell 2.2 Twin Screw Supercharger
Richard Racing blower pulley
Metco 100mm idler
Air/Fuel:
Steeda CAI
Kenne Bell boost-a-pump
60LB injectors
Exhaust:
Dr. Gas x-pipe
Borla stinger cat-back w/ 4" tips
Drivetrain:
Hurst line lock
Steeda Tri-ax
Cooling:
Gords Heat exchanger
Canton Coolant expansion tank
Canton Intercooler expansion tank
Suspension:
Front:
Steeda Sport Springs
Rear:
Steeda Sport Springs
Maximum Motorsports full length subframe connectors
Horsepower by Hermann adjustable shocks
Guages/Pods:
Autometer steering column bezel
Autometer Triple A-piller
Autometer guages-Boost/Fuel pressure/Water temp
DynoJet Wideband Commander
Raptor shift light w/Red LED
Wheels/Tires:
Street
Front-17x9 Eagle F1 275/40ZR17
Rear- 17x10.5 BFGoodrich T/A KD 315/35ZR17
Drag Strip
Front- 15x3.5 Weld Draglites,
Rear- 15x10 Weld Draglites, 15x10x26 MT E/T streets
Well looks like a cool site and I hope to chat with some of you soon. Later.
--Ryan (a.k.a bub)
umm i'd use the
smiley, but since you are serving our country, god bless ya, enjoy it the flirting :P
to the site, sounds like an awesome cobra ya got, and I know its in good hands if Tim is working on it
smiley, but since you are serving our country, god bless ya, enjoy it the flirting :P
to the site, sounds like an awesome cobra ya got, and I know its in good hands if Tim is working on it
Yeah ive met Tim a time or two. I know Dave (GI Joe) pretty well and met Tim through him.
Originally posted by Scothew@December 19, 2005, 6:54 PM
Yeah ive met Tim a time or two. I know Dave (GI Joe) pretty well and met Tim through him.
Yeah ive met Tim a time or two. I know Dave (GI Joe) pretty well and met Tim through him.
Tim, Andy, and Rhonda are the best. I can't wait to pick my car up on the 20th,
Dave is a great guy..haven't had the pleasure to meet him personally but he sure knows a heck lot and has a sweet ride.
First off, let me say thank you for what you are doing. :usa: Second, welcome to the site. Sounds like you have a sweet ride. Don't drive it too hard when you get back home. And also my cousin is with the 3rd ID over there, Matt Williams. If you see him, say hi from everyone back home in Wisconsin. Take care and come home safe.
Welcome Ryan, take care of yourself in Iraq. Without the United States Military, there would be no United States as we know it. That's how important guys like you are Ryan to us civilians. Thanks for your service.
Tommy
P.S. SWEEEET RIDE you have!
Tommy
P.S. SWEEEET RIDE you have!
Thank you and Welcome. Your service is priceless. Be safe out there and tell your peeps at powerhouse to post those pics. I hope you kept a record of your mileage, because I know I would be driving it while you were gone.
Thanks for serving, yet again, over there. I know you 3rd ID guys are seeing the sandbox a lot since the war started. Keep your head down and hopefully you can make it to the first TMS meet in Birmingham, AL. It would be nice to see most of the military guys on the site there. It is all green...not what we have been used to lately!
P.S. I agree, get them to post pics!
P.S. I agree, get them to post pics!
Thread
Thread Starter
Forum
Replies
Last Post
AFBLUE
Off-Topic Chatter
4
Apr 25, 2008 03:52 PM





