***SHOW ME YOUR ENGINE BAYS***
#1
Bullitt Member
Thread Starter
Join Date: November 14, 2008
Location: Loooziana
Posts: 322
Likes: 0
Received 0 Likes
on
0 Posts
***SHOW ME YOUR ENGINE BAYS***
Cleaned and oiled my K&N Air cleaner today and was just messing around and snapped some pics of my engine bay. Pretty much stock.
SHOW ME YOUR ENGINE BAY!!!
SHOW ME YOUR ENGINE BAY!!!
#10
Cobra Member
Join Date: October 15, 2008
Location: Brew City
Posts: 1,373
Likes: 0
Received 0 Likes
on
0 Posts
Always willing to show off the bay!
Time for an upgrade though, as I am bored with the stock airbox (and power level)... so I need to get the Saleen Extreme CAI, GT500 pumps and smaller pulley installed
Time for an upgrade though, as I am bored with the stock airbox (and power level)... so I need to get the Saleen Extreme CAI, GT500 pumps and smaller pulley installed
#11
Could eat off some those motors.
My engine bay about 3 months ago, completely gutted and repainted
Almost done. Working on fuel cell and rear now
My engine bay about 3 months ago, completely gutted and repainted
Almost done. Working on fuel cell and rear now
Last edited by forensicsteve; 7/18/10 at 05:58 PM.
#14
They were from midwest auto gear. They fit ok. After a while they seem to pop up a little bit. I have the billit kit now, and I sold the midwest covers about a month ago. The large center billit piece was popping up a little bit too. I fixed that by putting 3/8th vehicle plastic conduit in the hole in the bottom where the billit center piece goes ove the main strut stud. The new billit ones are on solid now.
#19
Bullitt Member
Join Date: December 30, 2007
Location: Lemont
Posts: 494
Likes: 0
Received 0 Likes
on
0 Posts