I am placing a set of '02 mustang seats in my '66 fastback and ran into some trouble. When I bought the seats from the dealer and the 4 wire pigtail. They mentioned that I needed to use an ohm meter to figure out which side was +/-.

I know a little about wiring but this does not make sense to me whatsoever.

Anyone know which side or wires are +/- at this pigtail? Or can anyone check for me? I would really appreciate it greatly.

 

In fact, if someone owns one and can disconnect the 4 pigtail under the seat and use an ohm meter to tell which connector/wire is which. That's all I need.

 

if you can hold off a couple days i can check for you on my stang but i cant get to it till fri or sat.