Hey guys and gals I'm coming down to the final odds and ends with my first build and won't be dyno tuning till the spring (April) and I'm keeping it n/a!!

My mods are:

302 bored .40over to 308
Edelbrock Pedformer Heads
Edelbrock Performer 5.0 intake with the inlet opening ported to 75mm and polished runners
TrickFlow stage 1 cam
CraneCam 1.6 rocker arms
Granitelli motorsports 75mm mass air sen.
24lb ford racing fuel injectors
JLT Cold Air Intake (4in pipe necked down to 75mm)
75mm throttle body
March underdrive pulleys
Smog pump delete
AC delete
BBK Equal Length Headers
Bassani O/R X-pipe
Flowmaster 10series catback
190 fuel pump
MSD billet distributor
MSD box with rev control
Aod-e trans built for 600hp
B&M Hole Shot torque converter

I'm excited to get her on the road and wanted to get some feed back from everyone, so I can see how I did!
Thanks

 

Do you have any pictures?

 

The stat line is awesome. Curious to pics as well.

 

A 306 with those mods n/a I would think in the area of 280rwhp could be more depends on the dyno.

 

Here's a few pics

 

Liking it man! Does it perform as well as it looks?

 

I hope so we are pulling the old motor this week!!!

 

what where your hp goals?

 

Beautiful! The car and the engine! Appearance-wise on the engine you did a very tasteful job IMO

 

My goal is 295-300wrhp if possible !!

 

realistic goal. it may come a little short going through the auto but you never know. best of luck.

 

How are you tuning it?

 

he is bringing to a shop and doing it on a dyno going by his OP.

 

Ahh gotcha!

 

I was thinking of getting the SCT-4bank chip from american muscle but for $250 more I can get and custom chip made and dynoed

 

I would go for the custom.. It's made for your cars' specific needs and not for general use.

 

with the type of build your doing you are doing it right I woudn't use the sct. they are good for some things but getting her tuned by a good shop cannot be beat for a motor build.

 

Yea that's the road im gonna take its $575 for a custom tune on a dyno thats not bad and this company specializes in mustangs and I have never heard anything bad about them!!

 

Sounds great, that is the route I would go also. Have fun with project and keep us up to date

 

I will , thanks for the info!!!!