The Mustang Source - Ford Mustang Forums - Search Results

Notices
Search: Posts Made By: EF1
Showing results 1 to 20 of 20
Search took 0.03 seconds.
8/30/18, 05:07 PM
Replies: 141,008
Views: 3,781,344
Posted By 08GTCandyApple

:wave: Thanks, Scott! Hope you and the rest of...

:wave: Thanks, Scott! Hope you and the rest of the Brady Bunch are doing well ::)


Happy Birthday, Eduardo! :bday: :cheers:
8/5/18, 04:16 PM
Replies: 80
Views: 4,853
Posted By 5.M0NSTER

Keep the track pads in and drive it on the street...

Keep the track pads in and drive it on the street for about a week. 100 to 150 miles should be enough for them to scrub themselves even. Then the vibrations will go away
6/30/18, 05:22 PM
Replies: 1,460
Views: 69,348
Posted By HOSS429

yeah .. you `ve seen most of them but i think...

yeah .. you `ve seen most of them but i think there is a couple of new ones
https://youtu.be/AdeIpLTjD3M
6/30/18, 05:19 PM
Replies: 20
Views: 1,569
Posted By houtex

Well, hold on there padna, I got you covered on...

Well, hold on there padna, I got you covered on ALL THE THINGS now. :D

First, lemme point you to this:

https://www.youtube.com/watch?v=JpzefqEeVGE

That there is a fairly fantastic video on...
5/21/18, 09:14 PM
Replies: 44
Views: 2,482
Posted By 5.M0NSTER

It does, but it's minor of the 2 factors. Kinetic...

It does, but it's minor of the 2 factors. Kinetic E=1/2M*V^2 so velocity is what makes the most difference :)
And the fact the S550s are 460 hp to 526 HP means they move faster at the end of every...
5/4/18, 06:01 AM
Replies: 22,211
Views: 474,965
Posted By Gabe

The msp dude that claimed he was God, then...

The msp dude that claimed he was God, then claimed he was a Big Lion.
He can now claim to be banned from this forum.


.
4/24/18, 09:02 PM
Replies: 686
Views: 36,962
Posted By 5.M0NSTER

Funny you should ask :grin: R10/R8 is what I...

Funny you should ask :grin:

R10/R8 is what I ran up until last season (ran that combo 2014-2017) Good combo if you don't go more than 8/10 or 9/10. I recently upgraded to R12 and this season going...
4/15/18, 04:10 PM
Replies: 11,705
Views: 547,396
Posted By mayhem37

Simple to change the buttons. Check for videos on...

Simple to change the buttons. Check for videos on steering wheel replacement ... This is the
method that seemed the most common:
In short ...
Disconnect negative battery terminal!!!!!
On each...
9/2/17, 07:08 PM
Replies: 10
Views: 700
Posted By Rog13GTCS

No rubbing or clearance issues.

No rubbing or clearance issues.
6/22/17, 09:46 PM
Replies: 80
Views: 4,853
Posted By 5.M0NSTER

Not so far. And it's been 4000 miles. My street...

Not so far. And it's been 4000 miles. My street tires (Conti DW in 255/40-19) are not seeing any increased inside wear with -2.0 degrees of camber. I do not track them, but I take some ramps kinda...
5/27/17, 10:34 AM
Replies: 110
Views: 8,910
Posted By shaneyusa

The brackets are required to move your existing...

The brackets are required to move your existing calipers further away from the center of the axle. With this upgrade you are not getting any more braking surface area. It uses the same pad size as...
5/8/17, 05:46 PM
Replies: 14
Views: 1,500
Posted By tourer

Morgan goes in to the shop tomorrow, I'll keep...

Morgan goes in to the shop tomorrow, I'll keep you posted.
2/11/17, 05:54 PM
Replies: 17
Views: 1,075
Posted By 5.M0NSTER

I think your logic here is pretty solid. Try the...

I think your logic here is pretty solid. Try the middle on the front.

With the stock rear and middle setting on the front I can't get understeer during street driving. **
At the track I get...
12/31/16, 09:27 AM
Replies: 200
Views: 7,576
Posted By dmichaels

Agreed. The thicker ones can be too much for new...

Agreed. The thicker ones can be too much for new pads. But slightlybeien pads would would just fine. I've been using the 0.5 ones for a couple seasons now with no issues.
12/25/16, 02:58 PM
Replies: 200
Views: 7,576
Posted By dmichaels

It's the heat. They burn up. But with 2-piece...

It's the heat. They burn up. But with 2-piece rotors and the Ti pad backing plates I've been managing the heat, but the dust boots were already toast
10/24/16, 11:30 PM
Replies: 110
Views: 8,910
Posted By shaneyusa

The best prices I have found are at Autonation...

The best prices I have found are at Autonation White Bear Lake and Sunrise Ford in LA. Here are the links to them. Still looking. I have bought from both of these before with no issues. White...
10/19/16, 06:34 PM
Replies: 6
Views: 1,181
Posted By Mr. V

I had a squeaking noise and had exhausted every...

I had a squeaking noise and had exhausted every other option.
8/11/16, 07:09 PM
Replies: 36
Views: 3,942
Posted By 5.M0NSTER

Just the front. I don't think the rear needs to...

Just the front. I don't think the rear needs to be any stiffer than it already is in terms of sway. And on smooth tracks I can just increase the stiffness of the Koni yellows. I attribute the great...
6/5/16, 11:25 AM
Replies: 21
Views: 3,626
Posted By redonblackpony

1/4" MDF that has black melamine on one side. ...

1/4" MDF that has black melamine on one side.
( Home Depot ). I wrapped both sides with the fabric.
5/31/16, 09:42 PM
Replies: 11
Views: 1,165
Posted By 5.M0NSTER

Chasing a 911 GT3

First, I apologize for terrible video. I had the GoPro pointed waaay too high, so the white balance was all of. I got it view-able thanks to video editing.

Newer 911 GT3. Sounds awesome! And i...
Showing results 1 to 20 of 20


 
Forum Jump

Featured Sponsors

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.