2005 mustang crank no start
#1
2005 mustang crank no start
Hello
Last night I replaced my valve cover gaskets and replaced all my spark plugs and cables. This morning I go to start it and it cranks but no start. I checked everything and found my spark plugs aren’t getting a spark but everything is connected well. Any ideas? Thank you
Last night I replaced my valve cover gaskets and replaced all my spark plugs and cables. This morning I go to start it and it cranks but no start. I checked everything and found my spark plugs aren’t getting a spark but everything is connected well. Any ideas? Thank you
#2
The Analog Admin!
Join Date: November 27, 2004
Location: Visalia Ca.
Posts: 10,693
Received 2,992 Likes
on
2,199 Posts
Welcome!
@patrickp
See Second To Last pdf on Post One!
https://themustangsource.com/forums/...e-info-550470/
KC
@patrickp
See Second To Last pdf on Post One!
https://themustangsource.com/forums/...e-info-550470/
KC
The following users liked this post:
patrickp (4/28/24)
#3
THE RED FLASH ------ Master-Moderator
I'll second that!
The following users liked this post:
patrickp (4/28/24)
#4
Got it started!
Got the car back up and running but now it’s spitting out a P0352 code for Ignition Coil B. I already have new spark plugs and wires so I’m at a loss of what it could be. Any ideas?
#5
The Analog Admin!
Join Date: November 27, 2004
Location: Visalia Ca.
Posts: 10,693
Received 2,992 Likes
on
2,199 Posts
See Next PDF up From No Start.
Shows Codes And Diag Process.
I would Think if It Was Running Fine Beforehand a Wire Got Stretched and or Broken Where it Plugs into Coil Pack. Look For a Connector That May have Got Pushed Pack as Well in Connector.
If it is Running Good and Just Has Code Disconnect Battery For Ten Minutes or Clear Code if You Have Reader and See if it Comes Back!
KC
Shows Codes And Diag Process.
I would Think if It Was Running Fine Beforehand a Wire Got Stretched and or Broken Where it Plugs into Coil Pack. Look For a Connector That May have Got Pushed Pack as Well in Connector.
If it is Running Good and Just Has Code Disconnect Battery For Ten Minutes or Clear Code if You Have Reader and See if it Comes Back!
KC
Thread
Thread Starter
Forum
Replies
Last Post