Roush Vent Gauge Pod & AeroForce Interceptor Gauge Installed
 

Installed a Roush Vent Pod and an AeroForce Technology Inc., Interceptor gauge today. The Interceptor gauge install was the easiest ever, just plug it into the OBD II connector. Now on to the hard part, programming the gauge parameters!

http://i955.photobucket.com/albums/a...s/S2010055.jpg

Congrats! I have the same setup in mine, too! :)

I've been looking at these, how hard was it to bring the wire from the air vent? Did you have to take stuff apart?

Running the wire was a piece of cake. Other than the outer and inner duct, nothing needs to come apart. I simply ran a welding rod down the duct opening to the driver’s side foot well then electrical taped the wire to the rod and pulled the rod out to access the wire. That was all that was necessary. The Roush instructions are very good on the install steps.

Alright, I might have to get one, at the price they sell for, those pods are really neat.

Yep, very easy install, and I didn't even need to use anything to feed the wire up into the vent. I had the Interceptor gauge in my last car, so I wanted one for this, too. :)

Just be careful removing the vent inserts, I snapped-off one of the vanes. No big loss, it's not going back in any time soon anyway! :D

,,Here are a few pictures ,,:nice: Attachment 97419

Attachment 97420

Attachment 97421 :D