No start, HELP!!!!!!
#1
No start, HELP!!!!!!
Ok, so I have a 2004 converted to a 3V
Today I changed the cam sensor and road test and it was fine. The car came with an SCT tuner and the check engine light was not illuminating, so I programmed the car back to stock. After that the car will not start. I checked the fuel pump out and all wires at the connector are getting power to them. I can't find any wiring diagrams anywhere. I am starting to lean towards the ECM being no good.
Any other input would be great
Today I changed the cam sensor and road test and it was fine. The car came with an SCT tuner and the check engine light was not illuminating, so I programmed the car back to stock. After that the car will not start. I checked the fuel pump out and all wires at the connector are getting power to them. I can't find any wiring diagrams anywhere. I am starting to lean towards the ECM being no good.
Any other input would be great
#3
Tried multiple times. All 7 wires at the connector are getting power to them. I even tried updating the firmware on the tuner and its not even recognizing the tuner. SCT website says it's a invalid S/N
Thread
Thread Starter
Forum
Replies
Last Post
orange3.9stang
2010-2014 Mustang
4
5/1/16 07:33 AM